Access Control 2.4 - How to add fingerprints to a remote clock

You will first need to setup employees in the Clockrite software and send the names to the terminal

This video guide explains how to do this  http://clockrite-support.helpscoutdocs.com/article/67-how-to-add-a-new-employee

Once that is done, open the Access Control software

This process assumes that you have set up the terminal in the Access Control software.  If not, then follow these instructions  http://clockrite-support.helpscoutdocs.com/article/190-access-control-adding-a-device

Now you need to copy the employee names from the clock to the Enrollment and Management software.

Click on ‘ Device to PC’ icon on the top toolbar

Click on ‘ Browse Users in device’ (this displays the users from the clock to the Enrollment & Management software)

The employee names now need to be transferred from the N ew User (Not in Local Database) list to the Users in Local Database list

Close ‘ Device to PC’ and click on the ‘User Management’ icon on the top toolbar

Click on the User Management icon (this is where you remotely register the employees fingerprints at the clock)

Fingerprint Registration screen (this is where the Enrollment & Management software communicates with the clocks fingerprint reader.  You will need the required employee at the clock ready to register their fingerprint.

If the fingerprint registration process fails try again.  

Once successful click OK to exit the Fingerprint Registration screen

You can view how many fingerprints are registered against each user in User Management then click FP Enroll