Adding 2 Sounders To 1 Clock
2 Sounders can be connected to a single clock. Wiring for this is shown further down the article.
Our multi tone sounder can be configured for 7 different tones. End users can change the tone using the dip switches provided.
It is compatible with our current ZK Terminals.
Volume: 100db at 100m
Input voltage: 12 - 24v DC. (We always advise 12v)
Input Connectors
Current mA: 35mA (based on 12v)
IP Rating: IP55
Dimensions
Tone 1 800/1000Hz @ 0.25 sec Alternating
8001000hz-@-0.25-sec-alternating.wav
Tone 2 500/1200Hz @ 0.3Hz 0.5 sec Slow Whoop
5001200hz-@-0.3hz-0.5-sec-slow-whoop.wav
Tone 3 1200/500Hz @ 1Hz - DIN / PFEER P.T.A.P.
1200500hz-@-1hz-din-pfeer-ptap.wav
Tone 4 544Hz (100mS)/440Hz (400mS) - NF S 32-001
544hz-(100ms)440hz-(400ms)---nf-s-32-001.wav
Tone 5 Bell
Tone 6 800/1000Hz @ 7Hz Sweeping
Tone 7 500-1200Hz 3.75sec /0.25sec. Australian Evac.
500-1200hz-3.75sec-0.25sec.-australian-evacuation-tone.wav
Configuring the Dip Switches for different tones
There are 2 dip switch link pins provided. These attach to the highlighted 6 pin block
****IMPORTANT NOTE: Only use a 12 volt bell with these clocks****
The sounder should be mounted on a wall
The back box is drilled as required to mount on the wall.
Note the correct orientation of the back box as indicated by the arrow.
The supplied power supplier unit (PSU) need to be modified.
Remove the small end from the PSU and strip the wires
Connect the +ive wire (identified with dashes along the wiring) to the Purple wire, the Grey wire to unmarked bell cable and the –ve wire to the bell marked cable
If you are connecting 2 sounders to the same clock simply connect 2 positive out and 2 negative out cables and connect these to the relevant sounders.
Connect the cables.as shown below.
*******************************************************************************************************************************
You can connect up to 2 sounders in parallel
Please see the wiring guide below
