C200 - Enable Check In/Out Feature
Please see below on how to set up the check in/out feature on your Clock;
- Press the M/OK button on the Clock and swipe the Admin Card to gain access to the Menus.
- Navigate to 'System' and press M/OK.
- Navigate to 'Keyboard' and press M/OK.
- Navigate to 'Left' and press M/OK.
- Change function to 'Status Key' and enter the number '0', change the name to 'Check-In'.
- Navigate to 'Right' and press M/OK.
- Change function to 'Status Key' and enter the number '1', change the name to 'Check-Out'.
If you are having difficulties setting this up, please don't hesitate to contact us.
For Clocks with ZMM Firmware (Typically serial number starting BYUL) please follow the instructions below.
- Press the M/OK button on the Clock and swipe the Admin Card to gain access to the Menus.
- Navigate to 'Personalize' and press M/OK.
- Navigate to 'Short Key Mappings' and press M/OK.
- Navigate to 'Left' and press M/OK.
- Change function to 'Punch State Options' and enter the number '0', change the name to 'Check-In'.
- Set the Switch Cycle to 'Never'
- Navigate to 'Right' and press M/OK.
- Change function to 'Status Key' and enter the number '1', change the name to 'Check-Out'.
- Set the Switch Cycle to 'Never'
- Go back to the 'Personalize' menu
- Select 'Punch State Options'
- Select 'Punch State Mode' to MANUAL
- Set 'Punch State Timeout(s)' to 10
- Set 'Punch State Required' to "ON"
If you are having difficulties setting this up, please don't hesitate to contact us.