How to register fingerprints - outdoor (C230) clock only
This process is ONLY for Outdoor C230 clocking terminals and not connected to LAN (Cat5)
You will need the Clockrite Admin Card
and the USB Keyboard that was provided with your system
Make sure the clock is power ON.
Plug the USB keyboard into the bottom of the clock (remove the rubber grommet)
Turn OFF the Num Lock (green light should be off) on the keyboard
Swipe the Admin Card
Press 1 on the keyboard then Enter.
Then type the employee number 101 or 102 or 103 etc and press Enter
Press the designated fingerprint 3 times as prompted.
Wait until the " Timeout" message is heard.
Once this is done that employee is sucessfully registered.
The employee can then clock in/out