C100 Proximity Clock - Bell Information

IMPORTANT NOTE: Only use a 12 volt bell with these clocks

The bell should be mounted on a wall within 1.5 metres of a 3 pin 240 volt power socket.

The bell back box is drilled as required to mount on the wall.

Note the correct orientation of the back box as indicated by the arrow.

When correctly mounted, the striker pin should be on the right hand side (three o’clock) position.

How to connect.

The supplied power supplier unit (PSU) need to be modified.

Remove the small end from the PSU and strip the wires.

Connect the +ive wire (identified with dashes along the wiring) to the RED (C100) wire, the BLACK (C100) wire to unmarked bell cable and the –ve wire to the bell marked cable

Connect the extended bell cable to the +ive connection in the bell and remaining connection from the PSU to the –ive connection in the bell.

Finish the bell installation by locating on the four securing lugs on the back box and turning the grey metal outer of the bell slightly clockwise.

Secure the bell by clicking the dark grey cover into place.