Getting Started - 4.2 - C200 Ethernet

Connecting the C200 Fingerprint Clocking Terminal to your Local Area Network

Please ensure the Clocking Terminal is installed and connected to a network point or router with a Cat5 Ethernet Cable before following the steps below. Changes to the network settings in the Clocking Terminal must be reflected in the ClockRite Software in order for the System to function correctly on your network. 

In this Article

Changing the IP address in the Clocking Terminal:

You'll need your Admin Card and a valid IP Address

This process may differ slightly depending on the model of your Clocking Terminal. Please check the images below against the menu screen and follow the relevant steps.

Terminals purchased before February 2020 

Terminals purchased after February 2020
  1. Press  M/OK 
  2. Scan the Clocking Terminal with the Admin Card. If you're unsure where the Proximity reader on the Terminal is, check this page. 
  3. Use the  arrow keys to highlight the ‘Comm’ Icon and press M/OK
  4. Use the  arrow keys to highlight the ‘Network’ Icon and press M/OK
  5. Use the  keypad to enter the IP address
  6. Press  M/OK to save changes   
  1. Press  M/OK 
  2. Scan the Clocking Terminal with the Admin Card. If you're unsure where the Proximity reader on the Terminal is, check this page. 
  3. Use the  arrow keys to highlight the ‘Comm’ Icon and press M/OK
  4. Use the  arrow keys to highlight the ‘Ethernet’ Icon and press M/OK
  5. Use the  arrow keys to highlight the 'IP Address' option and press M/OK
  6. Use the keypad to enter the IP Address
  7. Press M/OK to save changes
        

Changing the IP Address in the ClockRite Software

Once the Clocking Terminal has been connected it is important to make sure that the IP entered into the software matches the IP address assigned to the Clocking terminal.

1. Click on 'Clock ops' on the top Toolbar. This will open the 'Clock Setup' Screen.

2. Click on 'Setup' on the lower toolbar of the 'Clock Setup' screen. This will open the 'Clock Setup' screen.

3. Here you will see the default IP address for the Clocking Terminal. Change this to the desired IP address. You can also add a relevant Description by which to identify the terminal.

4. If you need to add another Clocking Terminal to the 'Clock Setup' screen, click 'New' on the lower toolbar.

If you have more than one Clocking Terminal to configure, ensure each has a unique IP Address.

Back to the Top

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us