Getting Started - 4.7 - C150 Ethernet
Connecting the C150 Proximity Clocking Terminal to your Local Area Network
Please ensure the Clocking Terminal is installed and connected to a network point or router with a Cat5 Ethernet Cable before following the steps below. Changes to the network settings in the Clocking Terminal must be reflected in the ClockRite Software in order for the System to function correctly on your network.
In this Article
Changing the IP address in the Clocking Terminal:
|
Changing the IP Address in the ClockRite Software
Once the Clocking Terminal has been connected it is important to make sure that the IP entered into the software matches the IP address assigned to the Clocking terminal.
1. Click on 'Clock ops' on the top Toolbar. This will open the 'Clock Setup' Screen.
2. Click on 'Setup' on the lower toolbar of the 'Clock Setup' screen. This will open the 'Clock Setup' screen.
3. Here you will see the default IP address for the Clocking Terminal. Change this to the desired IP address. You can also add a relevant Description by which to identify the terminal.
4. If you need to add another Clocking Terminal to the 'Clock Setup' screen, click 'New' on the lower toolbar.
If you have more than one Clocking Terminal to configure, ensure each has a unique IP Address.