Getting Started - 3.3 - C250/C150
Installing your C250 or C150 Clocking Terminal
You Will Need:
- Your C250/C150 Clocking Terminal, backplate, and supplied power pack
- The 4 rawl plugs, 4 long screws, and 1 grub screw that came inside the box with your C250/C150 Clocking Terminal
- A drill with an 8mm drill bit
- A phillips head screwdriver
If you'd like to print this page for reference you can do so using the printer icon on the to right of the page.
1
Using the
backplate as a guide, drill a minimum of three holes in the mounting wall at a height of approximately 1.3 meters
2
Insert the
rawl plugs, one in each hole
3
Screw the backplate in place using the
long screws
|
 |
|
4
Plug the power supply into the connection on the underside of the Clocking Terminal
Please use
only the power supply provided. Third party power supplies may damage the Clocking Terminal
|
 |
5
Mount the Clocking Terminal on the
backplate
6
Secure the underside of the Clocking Terminal to the
backplate using the
grub screw
7
Finally, power the Clocking Terminal on
|
 |
|
|
Back to the Top
