Getting Started - 4.5 - C400 Wireless

Connecting the C400 Facial Recognition Terminal to your Local Area Network via WIFI

Please ensure the Clocking Terminal is installed and powered on. If you gave us your network details when purchasing the System the Clocking Terminal should connect to your WiFi network automatically. When connected successfully, the display will show a green WiFi signal indicator similar to the example below.

If this is the case, you can skip this step and begin sending your Employee Profiles from the ClockRite Software to the Terminal.

If the WiFi signal indicator is grey, the Clocking Terminal is unable to connect automatically and you will need input your network information into the Terminal and the ClockRite Software. Please consult your network administrator and follow the steps below.   

If you'd rather connect via Ethernet cable or your Clocking Terminal does not support WiFi click here.

In this Article

Changing the Network Information in the Clocking Terminal

You will need: 

  •  Your Admin Card
  •  The SSID (network name) and password of the WiFi network you'd like to connect to.
  • You may wish to print out the using the keyboard page to take with you to the Clocking Terminal
  •  You may also need a valid IP Address for the Clocking Terminal, though our default IP (192.168.1.201) will work in most cases. 
1
Press the  M/OK button, and scan the  Admin Card at the bottom of the Clocking Terminal. If you're unsure where the Proximity reader on the Terminal is, check this page
2
Use the  arrow keys to select the 'Comm.' option. 
3
Use the  arrow keys to select the 'Wireless Network' option. 
4
On the 'Wireless Network' screen you can alter the SSID, and Password. Use the  arrow keys to navigate to the entry you want to change and press M/. Enter the required information using the keyboard and press  M/ to save . 
5
Once the SSID and Password have been set, press the up arrow key on the 'Wireless Network' screen to navigate to 'Advanced', then select the 'I.P Address' option. Enter the required information using the keyboard and press  M/ to save . 
6
    Press  ESC to exit the menus.

*** YOU WILL ALSO NEED TO ENSURE THAT THE LAN (ETHERNET) IP'S ARE SET TO 0.0.0.0 IF YOU ARE USING THE WIFI CONNECTION ***

Changing the IP Address in the ClockRite Software

Once the Clocking Terminal has been connected it is important to make sure that the IP entered into the software matches the IP address assigned to the Clocking terminal.

1. Click on 'Clock ops' on the top Toolbar. This will open the 'Clock Setup' Screen.

2. Click on 'Setup' on the lower toolbar of the 'Clock Setup' screen. This will open the 'Clock Setup' screen.

3. Here you will see the default IP address for the Clocking Terminal. Change this to the desired IP address. You can also add a relevant Description by which to identify the terminal.

4. If you need to add another Clocking Terminal to the 'Clock Setup' screen, click 'New' on the lower toolbar.

If you have more than one Clocking Terminal to configure, ensure each has a unique IP Address.

Back to the Top

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us