Go2Clock - Getting Started - 4b - Connecting Clocks

Step 4b: Connecting Clocks

Before setting up the cloud server settings, ensure that the clock is on the network and has DHCP enabled. Please find guides HERE for getting setup.

Terminals purchased before October 2019

Terminals purchased after October 2019
  1. Press the  M/ button, and scan the  Admin Card at the bottom of the Clocking Terminal. If you're unsure where the Proximity reader on the Terminal is, check this page
  2. Use the  arrow keys to select the 'Comm.' option.
  3. Use the  arrow keys to select the 'Web Setup Option' option.

  4. Ensure the settings are set as the following

    WebServer: URL mode

    zk.go2clock.com : 80

    EnableProxySever: Off
  1. Press the  M/ button, and scan the  Admin Card at the bottom of the Clocking Terminal. If you're unsure where the Proximity reader on the Terminal is, check this page
  2. Use the  arrow keys to select the 'Comm.' option.
  3. Use the  arrow keys to select the 'Cloud Server Setting' option.

  4. Ensure the settings are set as the following

    Server Mode: ADMS

    Enable Domain Name: On

    Server Address: zk.go2clock.com

    Enable Proxy Server: Off

    HTTPS: On

  5. Once complete, Esc and Use the  arrow keys to select the 'Ethernet' option.
  6. Within this option, ensure the DNS is set to 8.8.8.8
Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us