Getting Started - 4.8 - C150 Wireless

Connecting the C150 Wireless Proximity Clocking Terminal to your Local Area Network

Please ensure the Clocking Terminal is installed and powered on. If you gave us your network details when purchasing the System the Clocking Terminal should connect to your WIFI network automatically. When connected successfully, the WIFI SYMBOL at the top right of the display will be GREEN

If this is the case, you can skip this step and begin sending your Employee Profiles from the ClockRite Software to the Terminal. 

If the WIFI SYMBOL is grey, the Clocking Terminal is unable to connect automatically and you will need input your network information into the Terminal and the ClockRite Software. 

In this Article

Changing the Network Information in the Clocking Terminal

You will need: 
  • Your Admin Card 
  • The SSID (network name) and password of the WiFi network you'd like to connect to 
  • You may wish to print out the using the keyboard page to take with you to the Clocking Terminal
  • You may also need a valid IP Address for the Clocking Terminal, though our default IP (192.168.1.201) will work in most cases. 

This process may differ slightly depending on the model of your Clocking Terminal. Please check the images below against the menu screen and follow the relevant steps.

  1. Press the M/ Button 
  2. Scan the Clocking Terminal with the Admin Card. If you're unsure where the Proximity reader on the Terminal is, check this page. 
  3. Use the arrow keys to highlight the Comm Icon and press OK
  4. Use the arrow keys to highlight the Wireless Network option and press OK
  5. If the IP Address needs to be changed:
  6. Use the  arrow keys to scroll through the list of available networks to the Advanced option (usually at the bottom), and press OK
  7. Ensure DHCP is set to OFF
  8. Select the IP Address option and alter the details as needed
  9. Press ESC to return to the list of available networks
  10. Use the  arrow keys to select the correct WiFi network
  11. Enter the WiFi password using the keyboard
  12. Press M/OK to save changes, then ESC to exit to the main screen. Wait for the 'W' on the Terminal's home screen to turn green.

*** YOU WILL ALSO NEED TO ENSURE THAT THE LAN (ETHERNET) IP'S ARE SET TO 0.0.0.0 IF YOU ARE USING THE WIFI CONNECTION ***

Changing the IP Address in the ClockRite Software

Once the Clocking Terminal has been connected it is important to make sure that the IP entered into the software matches the IP address assigned to the Clocking terminal.

1. Click on 'Clock ops' on the top Toolbar. This will open the 'Clock Setup' Screen.

2. Click on 'Setup' on the lower toolbar of the 'Clock Setup' screen. This will open the 'Clock Setup' screen.

3. Here you will see the default IP address for the Clocking Terminal. Change this to the desired IP address. You can also add a relevant Description by which to identify the terminal.

4. If you need to add another Clocking Terminal to the 'Clock Setup' screen, click 'New' on the lower toolbar.

If you have more than one Clocking Terminal to configure, ensure each has a unique IP Address.

Back to the Top

Did this answer your question? Thanks for the feedback There was a problem submitting your feedback. Please try again later.

Still need help? Contact Us Contact Us